Bell Boots – The right way to Use Them on Your Horses

Bell boots are a horse’s first line of defense towards their own sharp back feet. They wrap across the entrance hoofs and cover the vulnerable coronary band and heel bulbs, which are crucial for stopping lacerations to these sensitive areas.

We regularly use bell boots when training our horses or for those prone to overreaching and injuring themselves. However not all horses need bell boots.

What’s the aim of bell boots for horses?

Bell boots are protective equipment that attaches to the horse’s front feet. The bell boot serves two functions for equestrians: it protects their horses’ from injury and prevents their back ft from hitting the horseshoes on their entrance feet and pulling them off.

When they run, some horses tend to overreach and strike the front of their rear hoofs into the back of their front feet. The soft regions on the heel bulb and coronary band are most vulnerable to injury from this hitting.

What do bell boots protect?

The frequent space damaged is the heel bulb, coronary band, and decrease pastern. Sometimes an overreach injury could be severe and cause everlasting damage.

Heel bulbs are the region that the majority usually gets injured by overreaching. The heel bulb is the fleshy part of the rear section of a horse’s foot – proper above their hairline and below their pasterns.

A horse’s rear hoof can strike the heel bulb with such a force that it cuts by way of flesh and severely injure your horse, causing pain, swelling, and profuse bleeding. In some cases, horses develop lengthy-lasting problems and lameness.

Probably the most severe accidents happen when a horse strikes into the back of its pastern. Higher up overreach accidents on the back of their leg might also find yourself with them in surgical procedure because of lacerating tendons or going into tendon sheath just above the fetlock area.

How do horses wear bell boots?

There are main types of bell boots, pull-on and open bell boots with velcro closures. Pull-on boots are typically made of rubber and slide over your horse’s foot. They’re straightforward to clean and nice for horses who need boots during turn-out and sometimes get their toes wet.

Fitting pull-on bell boots

Pull-on bell boots shouldn’t fit comfortable on your horse’s pastern but rather be loose. If they’re tight, they can irritate the horse skin and rub it raw. To assist stop chafing, some bell boots are fleece lined, which is nice but fitting your boots accurately is still important.

Ideally, try to be able to fit a finger between the top of the bell boot and your horse’s decrease leg. However it is best to only be able to fit one finger because if the boots are too massive, they will slide off your horse’s foot. When your horse is standing on a flat surface, the back of the boot ought to nearly touch the ground.

Most bell boots come in 4 sizes: small, medium, large, and extra-large. Typically Arabians and Quarter horses use medium, Thoroughbreds giant, and additional-large fit Warmbloods. There may be a lot of variation in manufacturer sizing, so it’s greatest to be safe and read opinions before buying.

Putting pull-on bell boots on your horse.

Putting pull-on bell boots on your horse isn’t always easy and takes some practice. First, turn the bell boot inside out. Then lift your horse’s foot and put the bell boot on, starting at the backside of it.

As you put it on, pull hard to stretch it, work your way up to where it is smaller, and then tug on it until you can fit your horse’s hoof through. As soon as it’s on, flip it down, and the boot is ready.

Versatile bell boots that stretch simply work best to get the most effective fit and are simpler to recover from the horse’s hoof.

Putting on open bell boots

Putting on open bell boots in your horse is easy. You just wrap them across the horse’s hoof and then safe them with velcro straps. Some have a hook-and-loop closure so you may adjust to fit different measurement feet.

Bell boots designed with velcro straps are typically more costly, however they prevent time getting them on and off, and most are made of sturdier materials than their pull-on counterparts.

How do you know if your horse wants bell boots?

An easy way to know in case your horse would benefit from wearing bell boots is that if they come back from working with scrapes or swelling on its heels. One other thing to look for is that if they’re constantly dropping shoes or steadily have loose shoes.

Bell boots help protect the shoes on your horse’s entrance ft from being pulled off once they’re hit by their back foot. This is common among some horses which have been turned out to play or ones running fast, but it can occur throughout different activities too!

Leave a Reply