Bell Boots – Learn how to Use Them on Your Horses

Bell boots are a horse’s first line of defense against their own sharp back feet. They wrap across the front hoofs and cover the vulnerable coronary band and heel bulbs, which are essential for preventing lacerations to these sensitive areas.

We often use bell boots when training our horses or for these prone to overreaching and injuring themselves. However not all horses want bell boots.

What’s the purpose of bell boots for horses?

Bell boots are protective equipment that attaches to the horse’s front feet. The bell boot serves purposes for equestrians: it protects their horses’ from injury and prevents their back ft from hitting the horseshoes on their entrance toes and pulling them off.

When they run, some horses are likely to overreach and strike the entrance of their rear hoofs into the back of their front feet. The soft areas at the heel bulb and coronary band are most inclined to injury from this hitting.

What do bell boots protect?

The widespread area damaged is the heel bulb, coronary band, and decrease pastern. Typically an overreach injury could be extreme and cause permanent damage.

Heel bulbs are the region that almost all usually gets injured by overreaching. The heel bulb is the fleshy part of the rear section of a horse’s foot – right above their hairline and beneath their pasterns.

A horse’s rear hoof can strike the heel bulb with such a force that it cuts by flesh and severely injure your horse, inflicting pain, swelling, and profuse bleeding. In some cases, horses develop long-lasting problems and lameness.

Essentially the most serious accidents occur when a horse strikes into the back of its pastern. Higher up overreach accidents on the back of their leg may also end up with them in surgery as a consequence of lacerating tendons or going into tendon sheath just above the fetlock area.

How do horses wear bell boots?

There are two main types of bell boots, pull-on and open bell boots with velcro closures. Pull-on boots are typically made of rubber and slide over your horse’s foot. They are simple to clean and nice for horses who need boots during turn-out and infrequently get their toes wet.

Fitting pull-on bell boots

Pull-on bell boots shouldn’t fit cosy in your horse’s pastern but rather be loose. If they are tight, they will irritate the horse skin and rub it raw. To help prevent chafing, some bell boots are fleece lined, which is good but fitting your boots accurately is still important.

Ideally, you ought to be able to fit a finger between the top of the bell boot and your horse’s lower leg. But it is best to only be able to fit one finger because if the boots are too giant, they will slide off your horse’s foot. When your horse is standing on a flat surface, the back of the boot ought to virtually touch the ground.

Most bell boots come in 4 sizes: small, medium, large, and additional-large. Typically Arabians and Quarter horses use medium, Thoroughbreds giant, and further-massive fit Warmbloods. There is a number of variation in producer sizing, so it’s best to be safe and read opinions before buying.

Putting pull-on bell boots in your horse.

Placing pull-on bell boots on your horse isn’t always simple and takes some practice. First, flip the bell boot inside out. Then lift your horse’s foot and put the bell boot on, starting at the bottom of it.

As you put it on, pull hard to stretch it, work your way up to where it is smaller, and then tug on it until you possibly can fit your horse’s hoof through. Once it’s on, flip it down, and the boot is ready.

Versatile bell boots that stretch easily work best to get the best fit and are simpler to recover from the horse’s hoof.

Putting on open bell boots

Placing on open bell boots in your horse is easy. You just wrap them across the horse’s hoof and then safe them with velcro straps. Some have a hook-and-loop closure so you possibly can adjust to fit completely different measurement feet.

Bell boots designed with velcro straps are typically more costly, however they prevent time getting them on and off, and most are made of sturdier materials than their pull-on counterparts.

How do you know if your horse needs bell boots?

A straightforward way to know in case your horse would benefit from wearing bell boots is that if they arrive back from working with scrapes or swelling on its heels. One other thing to look for is if they’re constantly shedding shoes or frequently have loose shoes.

Bell boots help protect the shoes in your horse’s entrance ft from being pulled off once they’re hit by their back foot. This is common amongst some horses which have been turned out to play or ones running fast, but it can happen during other activities too!

Leave a Reply