Bell Boots – Learn how to Use Them on Your Horses

Bell boots are a horse’s first line of protection against their own sharp back feet. They wrap across the entrance hoofs and cover the vulnerable coronary band and heel bulbs, which are essential for stopping lacerations to these sensitive areas.

We regularly use bell boots when training our horses or for those prone to overreaching and injuring themselves. But not all horses need bell boots.

What’s the aim of bell boots for horses?

Bell boots are protective equipment that attaches to the horse’s entrance feet. The bell boot serves two functions for equestrians: it protects their horses’ from injury and prevents their back toes from hitting the horseshoes on their front toes and pulling them off.

Once they run, some horses tend to overreach and strike the entrance of their rear hoofs into the back of their front feet. The soft regions at the heel bulb and coronary band are most susceptible to injury from this hitting.

What do bell boots protect?

The common area damaged is the heel bulb, coronary band, and lower pastern. Generally an overreach injury can be severe and cause permanent damage.

Heel bulbs are the region that the majority often gets injured by overreaching. The heel bulb is the fleshy part of the rear section of a horse’s foot – proper above their hairline and below their pasterns.

A horse’s rear hoof can strike the heel bulb with such a force that it cuts by way of flesh and severely injure your horse, causing pain, swelling, and profuse bleeding. In some cases, horses develop lengthy-lasting problems and lameness.

Essentially the most critical accidents occur when a horse strikes into the back of its pastern. Higher up overreach accidents on the back of their leg can also end up with them in surgery as a consequence of lacerating tendons or going into tendon sheath just above the fetlock area.

How do horses wear bell boots?

There are two primary types of bell boots, pull-on and open bell boots with velcro closures. Pull-on boots are typically made of rubber and slide over your horse’s foot. They’re straightforward to clean and nice for horses who want boots during flip-out and sometimes get their feet wet.

Fitting pull-on bell boots

Pull-on bell boots shouldn’t fit comfortable in your horse’s pastern but relatively be loose. If they are tight, they will irritate the horse skin and rub it raw. To help forestall chafing, some bell boots are fleece lined, which is good but fitting your boots accurately is still important.

Ideally, you need to be able to fit a finger between the top of the bell boot and your horse’s decrease leg. However you must only be able to fit one finger because if the boots are too large, they will slide off your horse’s foot. When your horse is standing on a flat surface, the back of the boot ought to nearly contact the ground.

Most bell boots are available in 4 sizes: small, medium, massive, and additional-large. Typically Arabians and Quarter horses use medium, Thoroughbreds massive, and additional-large fit Warmbloods. There is plenty of variation in producer sizing, so it’s finest to be safe and read reviews earlier than buying.

Placing pull-on bell boots in your horse.

Putting pull-on bell boots on your horse isn’t always simple and takes some practice. First, flip the bell boot inside out. Then lift your horse’s foot and put the bell boot on, starting on the backside of it.

As you set it on, pull hard to stretch it, work your way up to the place it is smaller, and then tug on it till you can fit your horse’s hoof through. As soon as it’s on, flip it down, and the boot is ready.

Versatile bell boots that stretch simply work best to get the best fit and are easier to get over the horse’s hoof.

Putting on open bell boots

Placing on open bell boots in your horse is easy. You just wrap them across the horse’s hoof after which secure them with velcro straps. Some have a hook-and-loop closure so you’ll be able to adjust to fit totally different measurement feet.

Bell boots designed with velcro straps are typically more costly, but they prevent time getting them on and off, and most are made of sturdier materials than their pull-on counterparts.

How do you know if your horse wants bell boots?

An easy way to know in case your horse would benefit from wearing bell boots is that if they come back from working with scrapes or swelling on its heels. Another thing to look for is that if they’re consistently dropping shoes or often have loose shoes.

Bell boots help protect the shoes in your horse’s entrance feet from being pulled off when they’re hit by their back foot. This is frequent amongst some horses that have been turned out to play or ones running fast, but it can happen throughout other activities too!

If you liked this report and you would like to acquire much more info with regards to bell boots and splint boots kindly go to the web-site.

Leave a Reply