Bell Boots – How to Use Them on Your Horses

Bell boots are a horse’s first line of defense towards their own sharp back feet. They wrap around the front hoofs and cover the vulnerable coronary band and heel bulbs, which are essential for stopping lacerations to those sensitive areas.

We frequently use bell boots when training our horses or for these prone to overreaching and injuring themselves. However not all horses need bell boots.

What’s the purpose of bell boots for horses?

Bell boots are protective equipment that attaches to the horse’s front feet. The bell boot serves functions for equestrians: it protects their horses’ from injury and prevents their back feet from hitting the horseshoes on their front feet and pulling them off.

Once they run, some horses are likely to overreach and strike the entrance of their rear hoofs into the back of their front feet. The soft regions at the heel bulb and coronary band are most susceptible to injury from this hitting.

What do bell boots protect?

The common space damaged is the heel bulb, coronary band, and lower pastern. Sometimes an overreach injury may be extreme and cause permanent damage.

Heel bulbs are the area that almost all usually gets injured by overreaching. The heel bulb is the fleshy part of the rear part of a horse’s foot – proper above their hairline and below their pasterns.

A horse’s rear hoof can strike the heel bulb with such a force that it cuts by way of flesh and severely injure your horse, causing pain, swelling, and profuse bleeding. In some cases, horses develop long-lasting problems and lameness.

The most severe accidents occur when a horse strikes into the back of its pastern. Higher up overreach accidents on the back of their leg might also end up with them in surgery on account of lacerating tendons or going into tendon sheath just above the fetlock area.

How do horses wear bell boots?

There are major types of bell boots, pull-on and open bell boots with velcro closures. Pull-on boots are typically made of rubber and slide over your horse’s foot. They’re easy to clean and nice for horses who need boots throughout flip-out and sometimes get their feet wet.

Fitting pull-on bell boots

Pull-on bell boots shouldn’t fit snug on your horse’s pastern however quite be loose. If they’re tight, they can irritate the horse skin and rub it raw. To help forestall chafing, some bell boots are fleece lined, which is nice however fitting your boots correctly is still important.

Ideally, you ought to be able to fit a finger between the top of the bell boot and your horse’s decrease leg. However you need to only be able to fit one finger because if the boots are too giant, they will slide off your horse’s foot. When your horse is standing on a flat surface, the back of the boot should nearly contact the ground.

Most bell boots are available 4 sizes: small, medium, massive, and additional-large. Typically Arabians and Quarter horses use medium, Thoroughbreds massive, and additional-giant fit Warmbloods. There is a variety of variation in producer sizing, so it’s best to be safe and read opinions earlier than buying.

Placing pull-on bell boots in your horse.

Placing pull-on bell boots in your horse isn’t always straightforward and takes some practice. First, turn the bell boot inside out. Then lift your horse’s foot and put the bell boot on, starting on the bottom of it.

As you set it on, pull hard to stretch it, work your way as much as where it is smaller, after which tug on it till you possibly can fit your horse’s hoof through. Once it’s on, flip it down, and the boot is ready.

Versatile bell boots that stretch simply work best to get the most effective fit and are simpler to recover from the horse’s hoof.

Putting on open bell boots

Placing on open bell boots in your horse is easy. You just wrap them across the horse’s hoof and then secure them with velcro straps. Some have a hook-and-loop closure so you can adjust to fit different dimension feet.

Bell boots designed with velcro straps are typically more costly, however they prevent time getting them on and off, and most are made of sturdier materials than their pull-on counterparts.

How do you know in case your horse needs bell boots?

A straightforward way to know in case your horse would benefit from wearing bell boots is that if they arrive back from working with scrapes or swelling on its heels. Another thing to look for is if they’re continually losing shoes or ceaselessly have loose shoes.

Bell boots help protect the shoes on your horse’s front toes from being pulled off once they’re hit by their back foot. This is frequent amongst some horses which have been turned out to play or ones running fast, but it can occur during different activities too!

In case you loved this short article and you would love to receive more info with regards to bell boots and splint boots generously visit our own internet site.

Leave a Reply