Bell Boots – Find out how to Use Them on Your Horses

Bell boots are a horse’s first line of protection against their own sharp back feet. They wrap across the entrance hoofs and cover the vulnerable coronary band and heel bulbs, which are crucial for stopping lacerations to those sensitive areas.

We regularly use bell boots when training our horses or for these prone to overreaching and injuring themselves. But not all horses need bell boots.

What’s the purpose of bell boots for horses?

Bell boots are protective equipment that attaches to the horse’s entrance feet. The bell boot serves two purposes for equestrians: it protects their horses’ from injury and prevents their back toes from hitting the horseshoes on their entrance ft and pulling them off.

After they run, some horses are likely to overreach and strike the front of their rear hoofs into the back of their front feet. The soft areas at the heel bulb and coronary band are most inclined to injury from this hitting.

What do bell boots protect?

The widespread area damaged is the heel bulb, coronary band, and lower pastern. Generally an overreach injury might be severe and cause everlasting damage.

Heel bulbs are the area that the majority typically gets injured by overreaching. The heel bulb is the fleshy part of the rear section of a horse’s foot – proper above their hairline and beneath their pasterns.

A horse’s rear hoof can strike the heel bulb with such a force that it cuts via flesh and severely injure your horse, inflicting pain, swelling, and profuse bleeding. In some cases, horses develop lengthy-lasting problems and lameness.

Probably the most critical injuries occur when a horse strikes into the back of its pastern. Higher up overreach accidents on the back of their leg may additionally find yourself with them in surgical procedure resulting from lacerating tendons or going into tendon sheath just above the fetlock area.

How do horses wear bell boots?

There are main types of bell boots, pull-on and open bell boots with velcro closures. Pull-on boots are typically made of rubber and slide over your horse’s foot. They are straightforward to clean and nice for horses who want boots throughout flip-out and often get their ft wet.

Fitting pull-on bell boots

Pull-on bell boots shouldn’t fit comfortable in your horse’s pastern but reasonably be loose. If they’re tight, they will irritate the horse skin and rub it raw. To help prevent chafing, some bell boots are fleece lined, which is sweet but fitting your boots appropriately is still important.

Ideally, you need to be able to fit a finger between the top of the bell boot and your horse’s lower leg. But it is best to only be able to fit one finger because if the boots are too massive, they will slide off your horse’s foot. When your horse is standing on a flat surface, the back of the boot should almost contact the ground.

Most bell boots are available in four sizes: small, medium, giant, and further-large. Typically Arabians and Quarter horses use medium, Thoroughbreds large, and extra-giant fit Warmbloods. There’s a variety of variation in producer sizing, so it’s finest to be safe and read opinions earlier than buying.

Placing pull-on bell boots in your horse.

Putting pull-on bell boots in your horse isn’t always easy and takes some practice. First, flip the bell boot inside out. Then lift your horse’s foot and put the bell boot on, starting on the backside of it.

As you set it on, pull hard to stretch it, work your way up to where it is smaller, and then tug on it until you can fit your horse’s hoof through. Once it’s on, flip it down, and the boot is ready.

Flexible bell boots that stretch easily work best to get the perfect fit and are easier to get over the horse’s hoof.

Placing on open bell boots

Placing on open bell boots on your horse is easy. You just wrap them across the horse’s hoof after which safe them with velcro straps. Some have a hook-and-loop closure so you can adjust to fit totally different size feet.

Bell boots designed with velcro straps are typically more costly, however they save you time getting them on and off, and most are made of sturdier material than their pull-on counterparts.

How do you know in case your horse needs bell boots?

A simple way to know if your horse would benefit from wearing bell boots is if they arrive back from working with scrapes or swelling on its heels. One other thing to look for is if they’re continuously dropping shoes or continuously have loose shoes.

Bell boots help protect the shoes on your horse’s entrance toes from being pulled off once they’re hit by their back foot. This is widespread amongst some horses that have been turned out to play or ones running fast, but it can happen throughout different activities too!

Leave a Reply